Engineering & construction machineryinfo@wodetec.com/+86-19939106571
Wode Heavy Industry

Integrated mixing, agitation and grout delivery.

The WGP250/350/100PI-D combines a mixer, agitator and piston grout pump for continuous cement mixing and grouting in surface and underground engineering. The mixer prepares water, cement and compatible additives, then transfers the slurry to the agitator while the next mixing cycle proceeds. Hydraulic valves and butterfly-valve transfer controls support operation of the integrated plant.

Specifications at a glance.

WGP250/350/100PI-D · Technical specifications
ModelWGP250/350/100PI-D
Mixer volume250 L
Agitator volume (technical table)350 L
Mixer production at W/C = 14 m³/h
Mixer circulation capacity1200 L/min
Suitable water/cement ratio0.5–1
Agitator speed36 rpm
Water tank60 L
Grout pump modelGGH90
Grout pump maximum output100 L/min
Grout pump working pressure10 MPa
Dimensions (L × W × H)3300 × 1650 × 1500 mm
Weight1400 kg

The technical table lists a 350 L agitator; a conflicting 300 L value in the narrative is not used. The 1200 L/min figure is mixer circulation, not grout-pump delivery. Maximum output and working pressure are separate listed specifications. The source does not give an engine power rating for this model, so it is not inferred from other diesel plants.

Mixing, control and grout delivery.

01

Continuous preparation

The mixer feeds the holding agitator so mixing and grouting can proceed continuously.

02

Compact base frame

Mixer, agitator and piston grout pump are installed as one unit.

03

Hydraulic control

The source specifies Yuken relief and directional valves for the pump hydraulic system.

04

Transfer valves

Butterfly valves control transfer between mixer and agitator.

05

Temperature protection

An oil-temperature gauge controls the cooler fan and stops operation if temperature becomes excessive.

Match the plant to the project.

  • Ground stabilisation

    Soil grouting and earth-foundation stabilisation.

  • Tunnelling and waterproofing

    Tunnel-lining and waterproof injection.

  • Foundations and structures

    Underwater-foundation and bridge-deck grouting.

  • Geotechnical works

    Deep-well casing and slope-line injection.

Application areas; suitability and the grouting design require project-specific engineering assessment.

Define your working conditions.

Specify your slurry recipe, required pumping duty, available power supply and site layout when requesting a configuration.

Discuss your requirements ↗

LET’S DISCUSS YOUR REQUIREMENTS

Tell us about your project.

Material. Flow. Pressure. Power supply. Destination.

Request a quote

info@wodetec.com